Webb WERR17P, Operator'S Manual & Parts List, Page: 8 / 28

WARNING!
The following procedures must be carried out before you start the engine of your lawnmower.
!
STARTING THE ENGINE
Starting the engine
1.
Make sure that your mower is
on a safe, at area (a paved area
or path is ideal - avoid thick wet
grass and gravel surfaces) away
from fuel or fueling area to
make starting safe.
2.
Press the fuel primer bulb
5 times.
3.
Firmly hold the brake handle
with one hand, and then with
your other hand pull the cord
slowly until you feel resistance.
Then pull vigorously with one
positive action (Fig. 7). Guide the
cord back to it’s rest position (do
not release).
4.
To restart a hot engine, refer to
‘Point 3’
5.
To turn off your mower, release
the brake handle.
Fig 5
Fig 7
The mower is supplied without oil in the
engine. Refer to the B&S engine manual
before starting the engine for the first time.
Firstly, remove the warning label
from under the dipstick, then
remove the dipstick and slowly
pour SAE30 or 10W/30
lawnmower grade engine oil int
the engine via the oil filler
(as directed by
thr B&S engine manual).
Replace the dipstick and tighten.
Before you use the mower each
time, check the oil level
(fig. 2) and
if necessary top up with SAE30
or 10W/30 oil. To check the oil level,
unscrew the yowllow dipstick, wipe
with a rag and replace into the oil
filler (do not screw back in place),
remove the dipstick again and
check the level.
The oil level must be between the
min and max marks on the dipsick
(fig.3). Replace the dipstick and
screw into place.
Petrol is highly flammable so
extreme caution must be taken when
handling it. Always store petrol in
approved containers and you must
ensure that you use fresh petrol that it
less than 4-6 weeks old. Do not mix oil
with petrol.
To put petrol in the fuel tank, firstly
remove the warning label form
under the petrol cap. It’s best to fill
the tank using a clean funnel, but
never fill it completely
(fig. 4).
Instead, leave at least 13mm from
the bottom of the filler neck to
allow for expansion. Ensure that
you securely tighten the petrol cap
after filling.
(Funnel & fuel not
supplied).
INSTRUCTION MANUAL