LINE TRIMMER & BRUSHCUTTER
FITTING GUARD/SHIELD
1.
Install the safety cover onto the sha with the safety cover bracket.
2.
Align the four screws of the cover with the safety cover bracket
3.
Tighten the screws a er se ng the safety cover bracket at the appropriate pos on.
LINE TRIMMER
FITTING NYLON LINE CUTTING HEAD
1.
Align hole in adapter plate with hole in the sha and install Allen Key.
2.
Thread cu er head onto sha (turning it an -clockwise) un
is
t. Remove locking tool.
BRUSHCUTTER
FITTING THE METAL BLADE
1.
Install holder A, the blade , holder B, teeth washer, in this order
2.
Then clamp with the le -hand thread nut.
3.
Align hole of gear case and holder A, and insert Allen Key.
4.
Rotate blade-fastening nut with spanner in clockwise direc n un securely
tened.
5.
Install the Pin 2×16 and split legs to secure.
WARNING
EXCESSIVE VIBRATION OF THE BLADE INDICATES IT HAS NOT BEEN INSTALLED CORRECTLY.
STOP THE ENGINE IMMEDIATELY, CHECK THE BLADE INSTALLATION AND RE-INSTALL CORRECTLY. AN
INCORRECTLY INSTALLED BLADE CAN CAUSE INJURY.
ASSEMBLY
Remove the machine and contents from the carton. Be sure the carton is empty before discarding.
If you require any assistance with regards to the contents of the lawnmower contact us:
Tel: 01793 333212 - Mon – Fri 8.30am – 5.00pm (excl. Bank Holidays)
Email: [email protected]
MACHINE
FITTING D-HANDLE
1.
Place top handle onto drivesh
2.
Pos on lower handle, beneath the top handle in a comfortable opera ng pos on
3.
Tighten the four fixing screws.
FITTING THE HARNESS
1.
Place the clasp of the harness, through the Harness Eyelet located on the drivesha
2.
Adjust the Harness to ensure it is comfortable, but ht enough to allow you to operate the machine
appropriately.
JOINING ATTACHMENT TO THE POWER UNIT
1.
Un hten the hand-wheel, located on the coupler.
2.
Line up the a achment sh with the coupler and insert, pulling the locking pin on the coupler out to
house the a achment.
3.
When fully housed, secure by
tening the hand-wheel.
HEDGE TRIMMER
ADJUSTING THE CUTTING HEAD ANGLE (Fig 3)
1.
Stop the engine
2.
Turn the clamp lever an -clockwise to loosen
3.
Adjust the blade to the required angle, by moving the clamp level up or down the angle adjuster.
4.
Turn the clamp lever clockwise to
ten.
WEMC26 193868001 IM.indd 9
14/10/2016 13:48
