Thermo 50
Exhaust line
43
9
Exhaust line
The exhaust line (inside diameter 22 mm) can be routed with several
bends (270° altogether, minimum bending radius 50 mm).
The total length of the exhaust line must be not less than 500 mm.
The maximum line length equals 1000 mm.
The exhaust muffler should preferably be installed near the heater, but
at least 200 mm away from the heater.
The exhaust muffler must not be installed near the combustion air intake
opening.
Do not operate the Thermo 50 heater without a muffler.
The exhaust pipe opening must be located so that it cannot become
clogged with snow and mud.
Rigid pipes of unalloyed or alloyed steel with a minimum wall thickness
of 1.0 mm or flexible piping of alloyed steel only must be used as exhaust
line. The exhaust pipe is secured to the heater using a clamping collar,
for example. See the statutory regulations for other requirements.
Only for ADR: The statutory regulation of ADR (Accord européen relatif
au transport international des marchandises dangereuses par route)
governing the routing of the exhaust line, part 9 para. 9.2.4.7, must be
adhered to.
Fig. 15: Exhaust muffler
Direction of flow as desired
Fig. 16: Exhaust pipe opening
Installation position
An attachment is required no further than 150 mm from the end of the
exhaust pipe to ensure that the angle of 90°
±
10° is achieved
Discharge direction almost vertical 90°
±
10°
Thermo50_02_gb_g.fm Seite 43 Dienstag, 27. Mai 2003 12:08 12
