21
Dodge Sprinter Passenger Van
Concluding Work
1. Install all vehicle parts, panels and components removed during heater installation.
2. Secure all loose lines and cables with nylon cable ties.
3. Spray the heater components and electrical connections with an anti-corrosive wax coating.
Final Inspection
Inspect installation for:
– loose fasteners.
– Exhaust system routing and clamp tightness.
– Combustion air intake tube routing and clamp tightness.
– Loose fuel line clamps.
– Routing of fuel lines and fuel lines securely tied and protected against chafing and related damage.
– Loose wiring connections and battery connections.
– Routing of wiring harness and wiring harness securely tied and protected against chafing and related
damage.
Initial Start-up
1. Set time and day of week on heater timer according to operating instructions found in the owners
manual.
2. Switch on the Webasto heater by means of the instant heat button on timer and check:
– Timer panel and instant heat indicator illuminates.
– Initiation of start-up sequence.
– Successful start-up and operation (heat produced at heater outlet).
ATTENTION
More than one start-up attempt of the heater may be required to purge air from fuel system before heater
will start. Cycle heater Off and On after each failed start attempt until heater starts and runs successfully.
Should the heater fail to start or operate correctly, call your Webasto technical representative at:
1-800-555-4518
