background image

3. Temperature and humidity: 

1.

  Indoor temperature range: 0

℃-

+50

℃ (-

32

℉-

+122

℉ ) 

2.  Humidity testing range: 20%-95% 

3.  Outdoor temperature display range: -50 

℃ - 

+70 

℃ 

(-58 

℉ -

+158

4.  Values are checked every 12 seconds 

5.

  Temperature accuracy: +/- 1

℃ 

 

4. Weather forecast: 

1.  Weather forecast indicates 24 hours ahead based on the recording history. 
2.  Four weather forecast conditions: sunny, patchy clouds, overcast and rain. 
3.  Forecast is usually accurate under normal ventilated conditions, though may 

be inconsistent if the outdoor sensor is located indoors for a time or in air-
conditioned environment. 

 

5. Temperature alarm: 

1.  Default value of +70

℃ 

highest and -50

℃ 

lowest. 

2.  The relevant temperature and alarm symbol with flash when alarm sounds. 
3.  Just the alarm symbol will flash if the relevant channel is not displayed. 
4. The 

alarm 

will: 

a.  beep 3 times each second; 
b.  beep for 5 seconds every minute 

5.  Stopping the alarm: 

a.  Press any key to stop the alarm sounding. The corresponding 

temperature and symbol will still flash. 

b.

  The flashing stops automatically when the temperature is back within 

normal range.

 

 

GENERAL INFORMATION 
Synchronizing the units: 

Try changing the channels, as the radio signal may be getting blocked by another 
frequency,

 

such as cordless phones and wireless broadband routers. 

Remember to set the outside unit up first. On opening the back of the unit you will 
see a switch.  By moving the switch you can change the channel on the sensor. This 
will appear on the display in the top left hand corner (CH1-CH3). 

You then need to reset the base unit again. This can be achieved by removing the 
batteries for a few seconds. Then set the channel to match the outside unit before 
you set anything else up on the base unit. This can be achieved by pressing the 
channel button on the reverse of the unit, again this will appear in the little house on 
the display in the bottom right hand box.

 

Positioning of the outdoor sensor: 

The unit should be positioned up to 10 metres from the base unit.  The unit should be 
north facing where possible, as in direct sunlight it will give inaccurate readings.  We 
would suggest that you don't position it in an exposed area.

 

 

Town & Country, Bardon, Leicestershire, LE67 1TE E-mail 

[email protected]

 

 

Summary of Contents for WEA23

Page 1: ... Comfort index 8 Alarm plus 5 minute snooze 9 Low battery indication 10 Moon Phase Ⅱ Turning on for the first time changing battery and resetting 1 Insert the batteries into the outside sensor first then the main unit 2 The display will light up for 3 seconds When replacing the battery or if resetting the unit then it will beep before receiving the radio signal The unit will search for 3 minutes t...

Page 2: ...to set 4 Press UP to change between 12HR 24HR time formats 5 Press DOWN to change between 6 When ALARM sounds press snooze and alarm will sound again after 5 minutes 7 Press Channel to change the RF CH1 CH2 CH3 8 Hold Channel for 2 seconds to reset saved data from the outdoor sensor 9 Press Alert to turn temperature alarm on off 10 Hold Alert for 2 seconds to set temperature alarm 11 Press MAX MIN...

Page 3: ...ing input 6 Press Alert to confirm and to go to the next setting 7 Press UP once to go forward a step hold for 2 seconds to cycle through at 8 steps per second speed 8 Press DOWN once to go back a step hold for 2 seconds to cycle back at 8 step per second speed 9 If no button is pressed for longer than 8 seconds the device will return to the standard display 10 Alert is on after setting Ⅳ Function...

Page 4: ...s automatically when the temperature is back within normal range GENERAL INFORMATION Synchronizing the units Try changing the channels as the radio signal may be getting blocked by another frequency such as cordless phones and wireless broadband routers Remember to set the outside unit up first On opening the back of the unit you will see a switch By moving the switch you can change the channel on...

Reviews: