3/8"- 6
Hex Nut
STEP 1
STEP 2
STEP 3
Installing the Transfer Tank
Install drain plug into drain hole.
Mark and Drill the Holes
Center the tank evenly between the bed sides and mark
eight mounting holes. For the “L” shaped tanks, mark
both holes of the side mounting angles, as well as four
evenly spaced holes of the longer front mounting angle.
For the Model 358, mark four holes evenly spaced in
each mounting angle.
Remove the tank and drill the marked hole locations
with a 7/16" drill bit.
• If any drilled holes fall between the ribs on
the lower part of the floor, it will be necessary
to use floor spacers between the tank mount-
ing angle and the floor.
Secure the Tank
1/4"
Drain Plug with
Pipe Tape
Pipe Tape
Vented Fuel Cap
Filler Cap Neck
3/8"
Flat Washer
3/8"
Lock Washer
3/8"
Body Washer
3/8-16 x 1-1/2"
Hex Head Bolt
INSTALLATION INSTRUCTIONS
Note:
If your truck bed is constructed of aluminum, use zinc rich primer to coat drilled holes.
Note:
Note:
Note:
• When installing model 352 Transfer Tank with a 27" tool
box in a full size short bed pickup, the Tank will need to
be mounted with filler openings toward center of the bed
to avoid tool box hitting wheel wells. Except full size short
wheel base Dodge pickup, where a 27" wide box will not fit.
Use one 7/16 x 1-1/2" plastic washer as a barrier between the
heavy flat washer and the truck bed.
ALUMINUM TRUCK BED INSTALLATION:
Before installing filler cap neck, wrap threaded end with
pipe tape. Do not use liquid or paste plumber’s pipe dope.
Install the filler cap neck, using a pipe wrench to tighten.
Install vented fuel cap.
Replace tank and bolt securely.
• Use pipe tape when using a manual or electric
transfer pump on the tank. Transfer tank and pump
must be grounded to prevent static charge build-up.