8
ASSEMBLY
Step 7: Installing roof tarp
NOTE:
●
The roof tarp (18) is pre-assembled with tube sleeves
along its lower part on each side.
●
Lay the roof tarp(18) on the ground next to the shed frame. Make sure
that the ends with the black straps are alongside the front door/back
panels (19, 20) and the tube sleeves are facing upward (fig. 20).
20
Tube sleeves
18
Black straps
●
Stretch the roof tarp (18) over the shed frame and make sure it is centered
on the frame (fig. 21). Use a ladder if necessary.
21
Tube sleeve
18
Bottom cross rail (6)
Caution!
●
If small adjustments are needed, two people should
pull the roof tarp (18) from the same side so that it
does not twist.
●
loosen the bottom cross rails (6) from the frame. Slide the cross bottom
rails (6) through the tube sleeves on one side of the roof tarp (18).
Re-assemble the clamps (12) (13)and fitting (15, 16, 17) and tighten
●
Make sure the cross rails (6) are level and horizontal.
22
●
Repeat the same procedure for the opposite side of the roof tarp (18).
●
Check and make sure all the bottom cross rails (6) are level and
horizontal, and are of the same height from the ground.
●
Tighten all the nuts and bolts at this stage.
●
Fasten the black straps at the four corners with the ratchet tie-down (14).
For details, see the corresponding instructions on page 7.
●
Now the shed is ready for use.
Caution!
●
Check and tighten the bottom cross rails (6) and
ratchets (14) monthly to ensure that the roof tarp
(18) is tight and safe.
●
When disassembling the shed, press the
spring-loaded bar and open the ratchet handle
completely to pull out the strap (fig. 23).
23
Spring-loaded bar
slightly (fig. 22).
●
Repeat the same procedure to install the back panel (20) to its proper
position.
17
16
12
Tube sleeve
inside tube sleeve
15
bottom cross rail (6)
17
16
15
13