6
ASSEMBLY
Step 4: Square up frame
●
Be sure the frame is standing at the desired location.
●
Level the frame both end-to-end and side-to-side.
●
Check and make sure the frame measures 10'(305 cm) in width (fig. 8).
●
Check and make sure the sections A to B and C to D be of equal distance.
(fig.8). If they are not of equal length, tap the corner leg of the longer
(using a
section
rubber mallet) inward until both diagonals are equal.
8
A
B
D
C
Step 5: Anchor the frame
CAUTION!
●
The shed must be well-anchored.
●
Do not attempt to install any of the fabric before the
frame is properly anchored.
●
If the ground is hard or rocky, pre-drill holes before
inserting the anchors.
●
Four anchors #19 are provided to secure the shed. They are to be
installed around the 4 bent corner legs #3 .
●
Screw the anchor head into the ground.
●
Attach the anchor #19 and the bent corner leg #3 with the cable #24
through the eyelets of them. Secure the cable by the cable clamp #25 (fig.9).
●
Repeat the same procedure for the other three anchors #19.
9
19
3
25
24
10'
10'
21
Zipper
Step 6: Install front door and back panels
●
Install the front door panel #21 first. During installation, ensure the zipper
of the front door panel #21 is closed (fig. 10).
10
12
13
●
Locate the top corner of front door panel near the cross rail tube #9.
Wrap the outer sleeves around the end rib(fig.12).
●
Unlock the buckle on the strap, slip the webbed belt around the
●
Repeat this step for the side
.
cross rails (fig.14)
and relock the buckle again
.
cross rail
(fig.13)
11
●
To make sure the strap will stay in the sleeve when assembly,
thread the strap through the spindle of the clamp hook #23.
11
●
Insert the S-hook of the clamp hook into the hole of the bent corner
leg #3. Pull the strap to tighten the rachet (fig.15)
15
9
3
14
9
9
Caution! Thread the straps following the direction of arrow as
shown in the diagram. (fig.11).
Back Side