WE-EF FLD121 #2, Installation And Maintenance Instructions Manual

Page: 4 / 7

3
Installation
The product must be installed and maintained by a
suitably quali Ƃ ed professional in compliance with latest
building/construction and/or electrical regulations and
relevant legislation.
Warning: Switch off mains electrical supply prior to
installing and connecting the luminaire.
Notice: If the luminaire is modi Ƃ ed by anybody other
than the original manufacturer, then the warranty will
no longer be valid and shall become the full respon-
sibility of the modifying person/organisation. Claims
based on defects attributable to improper installation
and/or application, and the consequences thereof, are
excluded.
Attention: The housing L containing the LED light
source is factory-sealed and does not need to be
opened during installation.
Installation Procedure
1) Switch off mains electrical supply.
2) Remove mounting ƃ ange A by loosening screws B .
Detach terminal connector C .
3) Determine position for Ƃ xing screws D .
Drill relevant holes E and insert wall plugs F .
Warning : Ensure not to damage any electric cable,
water pipe or other devices while drilling holes.
4) Feed mains supply cable G through the pressure
screw I , while setting mounting ƃ ange A in posi-
tion. The pre-installed packing ring H is suitable
for cable diameters 7 to 9.5 mm. For larger cable
diameters (9 to 12 mm) use the auxiliary packing
ring supplied. Then tighten the pressure screw I
(Fig. I).
5) To Ƃ x mounting ƃ ange A , pierce through nylon
plugs P by inserting and tightening screws D .
Attention : Nylon plugs P must remain in position
to provide sealing.
6) Check that rating shown on luminaire label conforms
with mains electrical supply.
7) Connect mains supply cable G leads to respective
terminals in terminal connector C :
a) ON/OFF (L = Phase, N = Neutral, = Earthing)
b) 1-10 V/DALI (L = Phase, N = Neutral,
= Earthing, DA/DA = DALI control line,
D–/D+ = 1-10 V control line).
8) Ensure that all surfaces are clean and dry. Position
luminaire over mounting ƃ ange A and attach termi-
nal connector C . Tighten screws B .
9) Loosen screws M and N slightly. Aim luminaire
in desired direction, retighten screws M and N .