5
Installation
The product must be installed and maintained by a
VXLWDEO\TXDOLƂHGSURIHVVLRQDOLQFRPSOLDQFHZLWKODWHVW
building/construction and/or electrical regulations and
relevant legislation.
Warning:
Switch off
and isolate the
mains electrical
supply prior to installing and connecting the luminaire.
Notice:
,IWKHOXPLQDLUHLVPRGLƂHGE\DQ\ERG\RWKHU
than the original manufacturer, then the warranty will
no longer be valid and shall become the full respon-
sibility of the modifying person/organisation. Claims
based on defects attributable to improper installation
and/or application, and the consequences thereof, are
excluded.
Installation Procedure
The luminaire is suitable for installation directly on
to an even surface, however it is recommended to
incorporate the optional planted root to ensure
maximum stability.
1)
Switch off
and isolate the
mains electrical supply.
2)
Check that rating
shown on luminaire
label
conforms
with mains electrical supply.
3)
A suitable recess to be provided for planted root
A
.
(QVXUHWKDWDVROLGIRXQGDWLRQDVZHOODVVXIƂFLHQW
mains cable length are provided.
4)
Remove head of luminaire
B
from bollard post
C
after loosening screw
D
with Torx T-20 tool and
rotating it anti-clockwise until it can be lifted up.
5)
Set cast base
G
in position and secure by inserting
and tightening bolts
F
and the post
C
is attached to
the base with retention bolts
E
.
6)
As per Fig. 2
Connect luminaire cable
H
to mains
supply
terminal block located on the gear tray
I
on
the
underside of the head
B
,
and is secured by the
clamp
J
.
Wiring
is as follows and should match the
labels on the
terminal block:
a)
ON/OFF
(L = Phase, N = Neutral, = Earthing)
b)
1-10V/DALI
(L = Phase, N = Neutral,
= Earthing, DA/DA = DALI control line,
D-/D+ = 1-10V control line).
7)
Return head of luminaire
B
to bollard post
C
and
secure by tightening screw
D
.
