ColorFlat 9 RGB
wdmlighting.com | 4106 Harry Hines Blvd, Dallas, Texas 75219 | 800-893-9787
Page 3
ColorFlat 7 RGBW/RGBW
Copyright (c) 2011 WDM Lighting
1. GETTING STARTED
What’s In The Box?
• 1 x
ColorFlat
™
9
rgb LED PAR Fixture
• 1x IEC Power Cord
• User Manual
Getting It Out Of The Box
Now that you’ve got The
ColorFlat
™
9 rgb
, you should carefully unpack
the box and check the contents to ensure that all parts are present
and in good condition. If anything looks as if it has been dam- aged in
transit, notify the shipper immediately and keep the packing material
for inspection. Again, please save the carton and all packing materials.
If a fixture must be returned to the factory, it is important that the
fixture be returned in the original factory box and packing.
Powering Up!
All fixtures must be powered directly off a switched circuit and cannot
be run off a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel is used solely for a 0% to
100% switch.
AC Voltage Switch - Not all fixtures have a voltage select switch, so
please verify that the fixture you receive is suitable for your local
power supply. See the label on the fixture or refer to the fixture’s
specifications chart for more information. A fixture’s listed current
rating is its average current draw under normal conditions. Check the
fixture or device carefully to make sure that if a voltage selection
switch exists that it is set to the correct line voltage you will use.
Warning! Verify that the voltage select switch on your unit
matches the line voltage applied. Damage to your fixture may
result if the line voltage applied does not match the voltage
indicated on the voltage selector switch. All fixtures must be
connected to circuits with a suitable Ground (Earthing).
wdmlighting.com | 4106 Harry Hines Blvd, Dallas, Texas 75219 | 800-893-9787
