507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
wibenchmfg.com
3
Assembly Instructions
for Optional Accessories
Connect the plastic runner to the mounting bracket by
inserting the runner’s tabs through the mounting bracket.
Bolt both ends of the plastic runner to the mounting bracket
with a ¼-20x5/8” flat head cap screw and ¼-20 hex nut.
Complete for both the left and right rails.
Identify the appropriate pilot holes by aligning the mounting
brackets on the desktop. The mounting bracket will align
with at least three holes. Holes will vary depending on leg
and desk type.
After identifying the correct pilot holes, use number 10
screws to fasten the mounting brackets to the desktop.If tote
rails go over the leg plates, use provided rubber washers.
• (2) Mounting Brackets
• (2) Clear Plastic Runners
• (1) 3” Deep Clear Tote Tray
• (4) 1/4-20x5/8” Flat Head Cap Screws
• (4) 1/4-20 Hex Nuts
• #10 3/4” Square Pan Screws
• Rubber Washers
• Screw Gun
• 3mm Drill Bit
Par ts List: (per desk)
Before you begin, please make sure all parts and proper quantities are included. Any parts damaged during shipment must be
reported within 5 days of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
Par ts List: (per desk)
Tools Required
Place desktop face down on protected surface.
Align tabs of the Backpack Hook with the metal
inserts.
Use joint connector bolts to fasten both of the tabs
of the backpack hook to the desktop.
• (1) Backpack Hook
• (2) Joint Connector Bolts ¼”-20x15mm
Tools Required
ELO® Desk
with Tote Tray
ELO® Desk
with Backpack Hook
• Screw Gun
• 5/32” Hex Bit
