2
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
ASSEMBLY
The assembly of this desk requires the
assistance of another person.
NOTE: Hardware packs are included in
packaging. You may receive more hardware
than needed. Discard any extra hardware after
assembly.
1. Screw
Hardware A
into the metal inserts in the
bottom of
Part ①
.
Hardware B
Hardware C
Part ①
3. Attach (4)
Hardware B
to the outer side of
Part ②
aligning it with the pre-drilled holes using
Hardware B
.
Tighten with a #2 square drive screw driver or a #2
square bit with a screw gun.
Repeat this step for
Part ②
(if applicable).
Hardware B
Hardware C
Part ②
4. While one person holding
Part ①
and another the
Part ③
, you will need to align connectors on the left
and right ends of
Part ②
with the connectors on the
left and right legs. Press down on the modesty panel
until it’s fully engaged.
Repeat this step for the other modesty panel if it’s
double sided.
5. Place
Part ④
on
Parts ①, ②
&
③
. Align bottom
of
Part ④
that has the pre-drilled holes to the
brackets that are located on
Parts ①, ②
&
③
.
Attach
Hardware B
to
Part ④
with (2)
Hardware C.
Tighten with a #2 square drive screw driver or a
#2 square bit with a screw gun.
6. Place cable grommets into the holes located on the
laminate top, if applicable.
Connectors
Part ①
Part ②
Part ③
Hardware B
Hardware C
Part ①
Part ②
Part ③
Part ④
2. Attach (2)
Hardware B
to the inner side of the
Part ①
aligning them with the pre-drilled holes using
Hardware C
. Tighten with a #2 square drive screw
driver or a #2 square bit with a screw gun.
Repeat this step for
Part ③
.
Hardware A
Part ①