10
Failure to properly install stop-clips to the bottom of the door may
result in serious injury or death
STEP 11
INSTALLING OPTIONAL TOP DRAFT
STOP
Close the door and secure it in the down position. Use a pencil to mark
the door panel corrugation that is parallel with the bottom of the
header/lintel from the outside of the opening. If this corrugation
protrudes below the header, mark the one just above. Open the door
until the marked corrugation is accessible. Stretch the top draft stop
across the door and attach it to the curtain on the marked corrugation
with the self-drilling screws provided, locating the screws on 12”
centers. Trim the top draft stop to clear the guides if required. When the
door is closed, the draft-stop should seal on the header.
Top draft stop may not seal on the
header if not installed on a corrugation
as shown.
STEP 12
INSTALLING THE OPTIONAL TENSION-PRO SPRING ADJUSTMENT
BRACKET
STEP #12a:
Install the Tension-Pro™ bracket on the left hand side of the curtain assembly per STEP #4 & #5 in
this manual. Insert cotter pin through hole in the axle end. Do not use large washer (shown in step #5) on the
Tension-Pro™ bracket side axle end. Bend the ends of the cotter pin to secure in position.
STEP #12b:
Stretch and attach spring end to the spring holder plate of the Tension-Pro™ bracket. Tighten the
flange nylon lock hex nut to keep spring in place.
NOTE:
WARNING
