3
NOTE:
Any of the three transmitter buttons
can be programmed to activate the door. In
multi-door installations, each button can
be programmed to activate a separate door.
Only one button at a time (per-transmitter)
can be programmed to activate a door.
To program the transmitter:
1. Place the emergency disconnect handle in
the manual door operated position. This is for
safety reasons.
2. Press program button on DoorMaster™
light fixture,
i
drive
®
,
pro
drive™, Quantum™ or
Classicdrive™ operator. LED will light or
i
drive
®
operator will beep once indicating that it is
ready to learn a transmitter.
3. Within 30 seconds, press and hold the
desired transmitter button(s); the
i
drive
®
operator will beep once. On the DoorMaster™
only, release the transmitter button and press
again.
4. Return the emergency disconnect handle to
motor operated position.
5. Press same transmitter button(s) again; door
should operate.
Transmitter is now programmed to operator.
6. To OPERATE, press the transmitter button.
NOTE:
i
drive
®
model only: The first
transmitter command after programming
will only open the door through a six inch
up/down cycle. Normal door operation will
then occur on all subsequent transmitter
commands.
Programming to Operator
Set-Up
TRANSMITTER
BuTTONS
IDRIVE
®
TORSION
IDRIVE
®
TORQuEMASTER
DOORMASTER
QuANTuM
TM
& CLASSIC &
PRODRIVE
PROGRAM
BuTTON
PROGRAM
BuTTON
PROGRAM
BuTTON
PROGRAM
BuTTON
Quick
Start
