4
Transmitter Buttons
Transmitter Buttons
Use the following procedure to program the
Wireless Keychain Remote transmitter button to
a SCENE button on the Wireless Gateway, WDHA-
12R. This procedure also is used to reassign a
transmitter button to a different SCENE button.
1. Press and Hold SCENE button you wish to
program, either Scene 1, 2 or 3, until the LED turns
off, then immediately release the SCENE button.
2. Press and hold the desired Transmitter button.
The LED on the Wireless Gateway will flash three
(3) times quickly to indicate the programming is
successful.
3. Release the transmitter button.
Note: Your Keychain Remote cannot directly operate
Z-Wave
™
modules, the Z-Wave
™
modules must
be programmed to the Gateway Scene to which you
have programmed your transmitter button.
4. To OPERATE, plug the Wireless Gateway into
AC power, then press the transmitter button
corresponding to the programmed SCENE which you
want to activate.
Best Practice Tip: Program the garage door opener
to a button by itself and SCENE’s to their own
transmitter buttons.
Use the following procedure to program the
Wireless Keychain Remote transmitter button to
a Wayne-Dalton Garage Door Opener Conversion
Module, Model WDRR-372R. This module will
allow your Keychain Remote Control to operate
any brand Garage Door Opener.
1. Install the Garage Door Opener Conversion
Module per the instructions provided with it.
2. Press and release the PROGRAM button on the
Conversion Module. The red indicator will turn on.
3. Press and release the desired transmitter button.
The Red LED indicator on the Conversion Module
will flash to indicate as successful operation.
6. To OPERATE, press the transmitter button
corresponding to the Conversion module.
Programming to Controller
Programming to Conversion Module
Scene
1
Scene
2
Scene
3
Delete
Copy
Choose 1
SCENE button
LED’s
Set-Up
Program Button
Red Indicator
Helpful hint: A broom handle can
be used to extend your reach for
depressing the program button.
Quick
Start
Quick
Start
