Waygate Technologies Krautkramer USM 100, Operating Manual, Page: 56 / 330

3 Initial start-up Starting the USM 100
56 Rev. 9 (09/2023) Krautkrämer USM 100
3.6 Starting the USM 100
Powering On
The Power key (1) is located on the top of the instru-
ment.
– Press the Power key for two seconds.
The software is initialized, the instrument carries out a
self-check and then switches over to stand-by mode.
In the factory setting, after switching on the instrument
and system boot-up, you will see the
Application desk-
top (see page 69) with all applications stored in the in-
strument and available for selection.
Depending on the settings (see Startup Application ,
page 110), the A-scan view (see page 73) can be dis-
played alternatively. In this case, the application select-
ed as the default is already loaded.
In case the instrument can not be started in the normal
way, you can reset or reinitialize the operating system
with a software update (see page 265).
1