Waygate Technologies Krautkramer USM 100, Operating Manual, Page: 164 / 330

5 Operation Evaluation
164 Rev. 9 (09/2023) Krautkrämer USM 100
Acceptance Level
This parameter is only visible when CNDAC has been
selected in Eval Mode .
You can set the acceptance level line according to the
required quality.
Code
This parameter is only visible when CNDAC has been
selected in Eval Mode .
You can select a standard according to the inspection
requirement.
The option Custom allows the specification of an own
reference block, whose data must be documented sep-
arately.
Cal Block
This parameter is only visible when CNDAC has been
selected in Eval Mode .
You can select a reference block.
Defect Length
This parameter is only visible when CNDAC has been
selected in Eval Mode .
The evaluation curve offset will be adapted to the value
entered here for the expected defect length.
SL
This parameter is only visible when CNDAC has been
selected in Eval Mode . Here you can set the Sizing Line
(SL) according to CNDAC.
RL
This parameter is only visible when CNDAC has been
selected in Eval Mode . Here you can set the Rejection
Line (RL) according to CNDAC.
EL
This parameter is only visible when CNDAC has been
selected in Eval Mode . Here you can set the Evaluation
Line (EL) according to CNDAC.