Waygate Technologies Krautkramer USM 10, Operating Manual

Page: 118 / 242

5 Operation Material Probe
118 Rev. - (09/2021) Krautkrämer USM 100
Frequency
With this function you can set the frequency of the re-
ceiver according to the frequency of your probe.
The frequency is set automatically when you select a
probe by its number or name (see page 117).
Probe Delay
This is the same function as in the function group
A-Scan (see page 118).
Probe Angle
With this function you can adjust the angle of incidence
of your probe for the test material. This value is required
for the automatic calculation of flaw position.
The probe angle is set automatically when you select a
probe by its number or name (see page 117).
Probe X-Value
With this function you can set the X value (distance of
probe front edge from the probe index or sound exit
point) of the connected probe.
This value is required for the automatic calculation of the
reduced projection distance.
Effective Diameter
With this function you can set the effective element or
crystal diameter of the connected probe.
The effective diameter is set automatically when you se-
lect a probe by its number or name (see page 117).
Delay Velocity
With this function you can set the sound velocity in the
delay line of the connected probe.
The delay velocity is set automatically when you select
a probe by its number or name (see page 117).