Wavion WS410, Installation Manual

Page: 37 / 66

Installing the Wavion WS-410 Metro Access Point
Installation Guide 37
12.
Apply silicon in the gap between the strip and the connector access cover.
Figure 3.23. Closing the Covers
13.
Create a drip loop of at least 10 inches by looping the cables back to the tray and using a
tie wrap to secure.
Connecting Peripherals
The WS-410 can source DC power on the Ethernet B connector pins 4,5 and 7,8, This allows
the WS-410 to power a backhaul device.
W
ARNING
:
If you are using a Wavion Injector, make sure you are not supplying
power to the injector until you insert the RJ45 connector into its socket, or you may
risk electric shock.
Close
connector
access cover
Close strip
Apply silicon