Wavetronix Click 500 Series, User Manual

Page: 88 / 109

CHAPTER 8
• CLICK 513 87
Figure 8.10 – General Tab
Setting Description
Sensor ID
The sensor ID number for the SmartSensor HD connected to the Click
513.
Sensor Interval
This is the number of seconds that the sensor stores Interval data.
This field is read only.
Alert On Time (Mul-
tiple of Sensor
Interval)
Allows you to enter the number of intervals the Click 513 will use to
determine alert status.
Alert Off Time (Mul-
tiple of Sensor
Interval)
Sets the minimum number of qualified intervals needed (out of the
monitored intervals) to turn off an alert.
Example.
If Alert On Time = 1 and Alert Off Time = 2, an alert will turn
on when one interval meets the requirements and will turn off when
those requirements are not met for two intervals.
Logic
Allows you to select the logic used to qualify an interval (AND re-
quires all enabled conditions to be true; OR requires only one enabled
condition to be true).
Poll Interval (ms)
Allows you to enter the number of milliseconds you want to the Click
513 to wait before it polls for Interval Data. The longer the interval
the bigger this number can be. This field is currently Ready only.
Table 8.5 – General Tab
The
513 > Approach
(
Approach 1
,
2, 3, and 4
) tabs allow you to set the threshold values for
the interval data (see Figure 10.12 and Table 10.6 for examples.)