Copyright ©2020 Wavesplitter AV Technology
|
Wavesplitter .com
TEL
：
1-510-0651-7800
：
V4
OPERATION MANUAL
Introduction
The WST-PEX004 Extender is a simple to use plug and play solution which lets the user extend HDMI signals up to 50m using a single low-cost
Cat.6 UTP cable (not included). For added convenience, IR signals (20-60KHz) can also be extended using the supplied IR Receiver and Emitter
cables.
Supporting resolutions up to Full HD 1920x1080@60Hz, video content can be seen with incredible clarity at distances up to 50m, which is perfect
for a variety of AV and digital signage applications.
The Extender features an HDMI loop-through output on the Transmitter with simultaneous viewing so that a local display can be connected to
monitor the remote display or to create an additional viewing zone. To ensure the maximum compatibility when two displays are connected, the
EDID data (that determine the supported audio/video formats) can be used from either a local monitor connected to the Transmitter, or the
remote display connected to the Receiver.
Power over Cat.6 (PoC) functionality enables the Extender to operate from a single power supply connected to the Transmitter, allowing the
Receiver to be positioned where there is limited access to power.
.
Key Features
Each set includes one Transmitter with loop out and one Receiver
Audio sampling rates up to 48kHz, support 7.1 channels
Supports 1080P@60Hz YUV4:4:4; maximum extension of 50m
DC12V/1.25A; supports PoC power supply
RX-end one-way infrared transmission to TX-end
Local and remote EDID Copy function
Extension distance dialing switch setting: Cat5e / Cat6 10m
～
50m
Supports Dolby®, TrueHD, DTS-HD®, Master Audio™
Package Contents
Transmitter x 1
|
Receiver x 1
|
12V/1.25A Multi-Country Power Adapter x 1
|
IR Emitter x 1
|
IR Receiver x 1
Panel Description
EQ DIP Switch
000
1~15meters
011
16~30meters
101
31~40meters
111
41~50meters
Note :
The Receiver has 3-bit EQ DIP switch for setting of
extension distance.
Follow the table on the right to set the DIP switch to the
correct binary combination for the required extension
distance.
※
When the distance up to 41~50m, please make sure the UTP cable up to 24AWG.
