Waves HPSA-7100-R Series, Installation And User Manual

Page: 83 / 179

HPSA-7100-R Series Installation and User Manual 57
P/N P01- 04946 Rev C
Installing the Batteries
.
FIGURE 6.5 Battery Location and Terminal Positions
4. Once the batteries are in place, secure the batteries using the clamp bar.
a. Place the clamp bar across the batteries.
b. Secure using five wignuts (provided).
5. Connect the battery cables as follows (refer to Figure 6.5 to identify batteries
called out in the instructions):
a. Attach one end of a 16-inch (40.6-cm) jumper cable to the POS + terminal of
Battery 3 .
b. Attach the other end to the NEG (
–
) terminal of Battery 4 .
c. Attach one end of another 16-inch (40.64-cm) jumper cable to the POS + of
Battery 1 .
d. Attach the other end to the NEG (
–)
terminal of Battery 2 .
e. Attach one end of a 7-inch (17.78-cm) jumper cable to the POS + terminal of
Battery 2 .
f. Attach the other end to the NEG (
–
) terminal of Battery 3 .
g. Attach the Ring terminal end of the POS (+) battery cable (36 inches/91.44
cm) to Battery 4.
It is normal to see an electrical arc when connecting the terminal ring to the
negative (black) post.