Waves HPSA-7100-R Series, Installation And User Manual

Page: 28 / 179

Introduction
2 HPSA-7100-R Series Installation and User Manual
P/N P01- 04946 Rev C
The HPSA-7100-R features include:
•
Highly intelligible live voice and tone announcements
•
Energy and cost efficient advanced amplification system
•
Omni-directional and directional speaker coverage options
•
HPSA-7100-R Battery Charger detects when batteries are below a certain level,
turns on and charges the batteries
•
Six discrete (Form C) trouble signals include: No AC, No Battery, Low Battery,
Door Open (tamper), Amplifier Fault, Drivers Short or Open
1.2 SYSTEM REQUIREMENTS
The following list identifies all required components for installing an HPSA-7100-R.
•
HPSA-7100-R
•
Optional HPSA-7100-V-KIT for 70.7 V
RMS
and 100 V
RMS
Audio Input
•
Appropriate Installation Instructions and Manuals as listed in Table 1.1
1.3 HOW DOES THE HPSA-7100-R WORK?
The HPSA-7100-R Series can be integrated and controlled by either Cooper Notification’s
SAFEPATH
®
4 (SP40S) Voice Evacuation Systems, SAFEPATH Mass Notification
Systems (SPMNS), or other external audio system.
The NAC input of the HPSA-7100-R is designed to activate and deactivate audio at the
HPSA by applying a DC Voltage in the appropriate polarity.
The HPSA-7100-R supports 1 V
RMS
and 25 V
RMS
audio input
along with
70.7V
RMS
or100 V
RMS
if the
optional HPSA-7100-V-KIT is installed
.
The HPSA is powered by a universal 100 - 240 VAC source and converts the AC to 36
VDC, 12.6 A, which is then fed to the Power Distribution Board (PDB) for additional
conversion and distribution. In the event of AC power loss to the HPSA, the PDB receives
+48VDC from the batteries for distribution of back-up power to the HPSA components.
TABLE 1.1
Installation Instructions and Manuals
Description Part Number
HPSA-7100-R Series Installation and User Manual P01-04946
HPSA-7100-V-KIT Installation Instructions P10-00096
Network Configuration Tool Administrator Manual P01-04933
The HPSA-MIC is an optional component of the HPSA-7100-R.
The
70.7V
RMS
or100 V
RMS
Audio Inputs require the
optional
HPSA-7100-V-KIT.