WaveRider EUM3006, Installation Manual

Page: 48 / 64

4: Installation
APCD-LM048-1.1 31
4.3.5 Connecting the End-User’s PC
There are many ways to connect the EUM3006 to the end-user’s PC, using Ethernet switches,
IP routers, etc. The discussion below is for the simplest, most direct method of connection,
using the provided PoE Injector.
1. Connect the end-user’s PC by attaching a crossover Ethernet cable (not provided)
between the Ethernet port on the end-user’s computer and the DATA only port on the
PoE Injector (marked “J2 DATA” in
Figure 7 ).
CAUTION: Connecting the End-User PC to the “J1 DATA &
PWR” port on the PoE Injector will provide a DC voltage that could
damage the end-user’s Ethernet interface. Ensure that the end-
user’s equipment in connected to the DATA only port (marked “J2
DATA” in Figure 7 ) of the PoE Injector and the EUM3006 or its extension
Ethernet cable is connected to the DATA & PWR port (marked “J1 DATA &
PWR”) in
Figure 7 ).
2. Plug the PoE Injector into an AC socket.
3. Check the Ethernet LEDs on the Ethernet interface of the end-user’s PC to ensure the
Ethernet connection between the EUM3006 and the end-user’s PC is active. Refer to
Table 5 for an explanation of the Ethernet LEDs normally provided on Ethernet
interface cards.
Table 5 Ethernet Interface Card LED Status Displays
4. When attempting to send data to, or receive data from, the Internet, check the
Ethernet Traffic LED to ensure data transmission is taking place. This LED flashes as
data traffic passes between the end-user’s PC and the EUM3006.
Ethernet LED Status
Ethernet Link LED This LED is lit when there is a correct connection to
the computer, and both ends are powered ON.
Ethernet Traffic LED Flashes when data passes through the Ethernet
connection in either direction.