WaveLAN ISA Adapter
WaveLAN ISA Adapter
WaveLAN ISA Adapter
The WaveLAN ISA Adapter, is a standard
“PC Card to ISA bus” adapter that you can
use to install WaveLAN/IEEE PC Cards into
computer devices that do not have a factory-
installed PC Card slot.
The WaveLAN ISA Adapter supports two I/O
addresses:
•
3E0-3E1
•
3E2-3E3 (factory-set default)
For most computers you do not need to
change the factory-set strapping of the
jumper (shown below) that determines the I/O
address.
NOTE:
The WaveLAN ISA Adapter was
especially designed for WaveLAN/IEEE
PC Cards. Although the adapter will
support most standard Type II PC
Cards as well, using this adapter in
combination with other PC cards is not
supported.
1. Inserting the Adapter
Unpack the WaveLAN IEEE 802.11 ISA Card
kit and verify that all items are present:
•
WaveLAN ISA Adapter card.
•
Instruction flyer (this document).
If any of the items described appear to be
damaged or missing, please contact your
supplier.
!
DANGER:
Carefully follow the instructions below.
Failing to do so may lead to an electric
shock and cause damage to your
computer and adapter.
1.
Switch off the power of your computer
and of all external devices connected to
your computer.
2.
Disconnect the power cords from your
computer and its external devices from
the mains sockets.
3.
Remove the top cover of your computer,
according to the instructions in the user’s
guide that came with your computer.
4.
Select an available slot for your adapter
and remove the metal filler strip (as
pictured above). Keep the screw for fixing
the adapter later.
5.
Gently insert the connector of the ISA
card into the slot (as shown below) until
the card is properly seated.
6.
Secure the card into place with the screw
that you removed in step 4.
7.
Put the computer cover back into place
according to the instructions in the user’s
guide that came with your computer.
8.
Reconnect all the external devices to
your computer.
9.
Re-insert the power cords and connect
them to the mains sockets.
10. Switch on the power of your computer.
11. Start-up your computer.
2. Introduce the card to your computer
The WaveLAN ISA Adapter does not support
“Plug & Play”. This means that after installing
the adapter into your computer, you must
“introduce” it to the operating system of your
computer.
•
For MS-Windows 95, 98, 2000 and NT
4.0, follow the instructions as described in
this flyer.
•
For MS-DOS systems, and Windows 3.x,
install the WaveLAN Card Access Driver
(WaveCAD) as described in the user’s
documentation of the WaveLAN/IEEE PC
Card.
