WB12.rev01
5
Fig 1.
Section 5.
Installing the Components
Fitting
Wavebrite™.
See Fig 1.
Locate a suitable position, refer to
Section 1.4
and
Fig.1
,
Note the Wavebrite™ system is
modular and each component and can be fitted remotely. Fix the mounting brackets and saddle
clamps. The FILTER/STRAINER 1 will require the most attention and should be installed where
it can be easily monitored visually and can be accessed with ease.
Attach the filter housings to the mounting brackets using the screws provided; ensuring the flow
direction is correct; there are arrows on the top filter housings and on the WHALE UNIVERSAL
WATER PUMP. The arrows must point in the direction of flow from the WHALE GREY WASTE
WATER SUMP towards the
WAVEBRITE™ FILTER MODULE. The flow direction through the
WAVEBRITE™ FILTER MODULE is left to right, but this can be changed by reversing the
WAVEBRITE WB1 CARTRIDGE in the
WAVEBRITE™ FILTER MODULE housing if required,
note flow direction arrow on WAVEBRITE WB1 CARTRIDGE.
Connect from the exit of Filter Strainer 1 to the pump and all the filters to the
WAVEBRITE™
FILTER MODULE with the 15mm hose supplied, quick connect fittings are supplied.
See the
Whale Pipe Fitting Guide supplied in the information pack.
The WHALE GREY WASTER WATER SUMP should be located so the head to the pump is no
more than 1000mm and the required pipe connections must be pre-drilled. The grey water
supply, such as from showers and basins are to go to the top connections, no hose or hose clips
are supplied for this. Connect from the lower 25mm connection to the Filter Strainer 1 using the
25mm flexible braided hose, 2 no. hose clips should be used on each end, these are supplied.
Galley waste water should be directed to the black water system due to the food waste
content and if directed to the Wavebrite system it may significantly reduce cartridge life.
A filter/strainer (not supplied) could be installed under sink to help prevent galley waste going to
the WHALE GREY WASTE WATER SUMP and the Wavebrite system if required.
It is required to have enough space below the filter units (25mm) to remove the filter bowls when
changing cartridges and at one end of the
WAVEBRITE™ FILTER MODULE (660mm)
check
the system specifications at Section 4 above.
Install the Tees and pressure gauges using thread tape.
Make the electrical connections to the pump, hour meter and WHALE GREY WASTER WATER
SUMP as per the instructions supplied with the electrical components and to required safety
standards. Locate the hour meter in a panel or an appropriate position. All electrical connections
to be carried out by and checked by a qualified marine electrical installer.
See section 5.1 Fig 2.
CAUTION
It is advisable to use
two hose clamps on
hose tails, so each
connection is double
clamped
.
NOTE
Refer to Whale
Water Systems
Catalogue for further
information
if
required.
whalepumps.com
WARNING
Electrical
connections are
required and to be
carried out by and
checked by a
qualified marine
electrical installer.
