Wave Eco Foam Spa, User Manual

Page: 18 / 20

CODE CAUSE SOLUTIONS
When the filtration system has wor
ked for
approx. 168 hours, FC code will appear to
advise y
ou to check the filte
r. Change) will
appear. The pump and heating buttons will be
disabled.
Check the filter is clean and change if
necessary. Press the ‘Filter’ button again.
The FC error code will disappear, water
temperature will be displayed, and all
functions will return to normal.
Blocked or dir
ty filte
r.
Low ambient temperature: the pipe and heater
are too cold to function correctly.
Check the filter is clean and change if
necessary.
Pour some warm water into the spa, and
the upper water outlet.
FC
SL
HL A blockage in the system is preventing water
circulation and causing a false high temperature
reading. Check the water flow fr
om the filter outlet;
if the flow rate is weak, non-existent or the
heater is making a grinding sound please:
1) Ensur
e filter does not need
replacement
2) Rinse the filter under a tap to clean
3) Check the filter is not
overtightened.
If debris is drawn into the motor, the
impeller may seize. Unplug at the mains,
drain water and remov
e the filte
r, then
check the outlet for obstructions.
Hard water can cause limescale build-up.
Turn off the spa at the mains, remove the
filte
r, then use a garden hose to run clean
water through the inlet and outlet to
loosen limescale or other debris. Use a net
to remove debris from the water.
SH Water temperature sensor issue Please contact Wave customer services.
FP Freeze Protect mode has been activated. To exit Freeze Protect (FP) mode, press
the HEATER button followed by the UP
button, until reaching 20°C. The controller
will return to its normal state.
If the FP code still shows after carrying
out the above, there may be a controller
malfunction. Please contact Wave
customer services.
CONTROL PANEL ERROR CODES