Press Tab
F
E
A
B
B
C
D
I
K
L
M
J
H
G
Press Down
Gasket
Push in
Align one side
PAGE 4
PAGE 5
MAINTENANCE
LAMP REPLACEMENT
Tools required: Phillips screwdriver and 5 mm hex driver
1.
Unplug the unit from the receptacle (A). Position the light
fixture upside down on a flat surface so that the light
fixture side plate with the AC cord is accessible. Loosen
all 6 screws to remove the side plate (B).
2.
Disconnect the side plate from the ballast (C).
3.
Slide the reflector completely out of the light fixture and
replace lamp (D).
4. Verify the lamps are properly installed and are securely in
place before reinstalling the reflector.
BALLAST REPLACEMENT:
Tools required: Phillips screwdriver, 5mm hex driver
1.
Unplug the unit from the receptacle (A). Position the light
fixture upside down on a flat surface so that the light
fixture side plate with the AC cord is accessible. Loosen
all 6 screws to remove the side plate (B).
2.
Disconnect the side plate from the ballast (C).
3.
Slide the reflector completely out of the light fixture and
take out all lamps on the reflector to avoid damaging the
lamp (D).
4.
Position the reflector so the the ballast facing up.
5. Disconnect the power supply. Press on tabs to pull wire
directly out of the socket (E).
6. Use the 5 mm hex driver and screwdriver to loosen nuts
and remove the mounting bracket (F).
7. Use the 5 mm hex driver and screwdriver to loosen nuts
and remove ballast (H).
8. Replace with new ballast and follow the wire diagram
provided on the ballast. When replacing the ballast and
inserting the wire, press tab in then insert wire.
MAINTENANCE:
REINSTALL REFLECTOR
1.
Align reflector with grooves inside the fixture (I).
2. Reconnect the ballast to the side plate.
3.
Verify the wires will not crimp or impede the installation (J).
4. Replace gasket if neccesary.
5.
Place hood on the side and align the bottom of the side plate with the hood (K). Secure the bottom with a screw. Press
down on the hood and connect the top of the side plate with the hood (L). Secure with all 6 screws (M).
TROUBLESHOOTING
PROBLEM:
All lamps will not light.
SOLUTION:
Lamps in shipping have moved and are not making a proper connection. See Lamp replacement procedure for proper lamp installation.
FOR QUESTIONS AND ANSWERS, VISIT OUR WEBSITE
www.wave-point.com