HOOD
BASE
This fixture may have an integral photo sensor that turns the fixture off during the day and on at night. The
photo sensor is not adjustable. The fixture could possibly cycle on and off due to light reflected from nearby
surfaces into the photo sensor. If cycling occurs, remove the photo sensor nut and install the swivel hood and
base.
The hood and base are adjustable. The hood can be rotated and the base can be cut along the dotted line to reduce overall length.
Check operation before cutting the base.
COLD WEATHER STARTING INFORMATION: For temperatures below 0˚F, leave the lamp on continuously - starting with warm
lamps. NOTE: If lamp starting becomes a problem in any cold weather application, remove the lamp form the fixture - bring the
lamp indoors so that it becomes warm - then reinstall the lamp into the fixture and leave the fixture on continuously. Do not place
lamp in an oven, microwave or similar heat producing devices.
BALLAST AND LAMP REPLACEMENT INSTRUCTIONS
Product contains an integrated Lamp/Ballast combination. To remove, grasp plastic area on each side of bulb area and rotate
counterclockwise. Replace with MAX 18W SBCFL(GU-24) that is marked with the UL and C, US Logo. Use SBCFL marked - Not for
use where directly exposed to water. Do not use SBCFL marked - Not for use in totally enclosed luminaire.
Clean only with mild soap and water. Avoid spraying with Cleansers,
Insecticides, and Pesticides that a petroleum based hydrocarbon
products. These will degrade Luminaire.
Mark means lamp contains
Mercury. Follow disposal laws.
See www.lamprecycle.org
Hg