Standard Components
Operation
The Solenoid On-Off ACV is designed to open fully or close drip-
tight as commanded by the 3-Way Solenoid Pilot. The Solenoid
Pilot commands the routing of fluid and pressure into and out of
the cover chamber of the main valve. When the Solenoid Pilot con-
nects the cover chamber of the valve to upstream pressure, the
valve closes drip tight. When the Solenoid Pilot connects the cover
chamber of the valve to downstream pressure (dry drain) or atmo-
sphere (wet drain), the valve opens fully. Engaging the Solenoid
Manual operator simulates power to the solenoid, manually con-
trolling the main valve. Disengaging the Solenoid Manual operator
returns the valve to electrical on-off service.
Specify voltage and MAIN VALVE actuation (energize to open
or close), and "wet" or "dry" drain PRIOR to ordering.
1
X
X
X
X
Y/FC
(ACS)
P/L
2
CLOSES VALVE
OPENS VALVE
FLOW
(AOS)
3
3
1. Prior to installation, flush line to remove debris.
2. Install valve so the flow arrow matches flow through the line, and gauges to monitor valve inlet and outlet pressures. A Position
Indicator can be installed to provide visual indication of valve position and operation without disassembly.
3. Install isolation valves upstream and downstream of the main valve.
4. Provide adequate clearance for valve servicing and maintenance. Refer to valve servicing dimensions on next page. Avoid installing
valves 6" and larger in the vertical position (main valve stem horizontal). Automatic Control Valves (ACVs) are designed for horizon-
tal in-line installation, with the cover facing up (main valve stem vertical). Slow operation or premature stem and guide wear may
occur if valve is not installed according to factory recommendations. Consult factory for detailed engineering review prior to order-
ing if valve is to be installed other than horizontally in-line.
5. If valve is equipped with a pilot control system, extra precautions should be made during installation to protect the piping circuit
from damage. Only remove the pilot control system from the valve if necessary. Tubing and fittings should be kept clean and
replaced exactly as removed. Consult appropriate hydraulic schematic to ensure proper re-assembly.
6. Connect solenoid wiring leads to desired switching device, using safe, standard electrical practices.
7. After installation, vent entrapped air from valve cover and pilot system by following instructions on Technical Bulletin.
Start-up of an automatic control valve requires that proper procedures be followed. Time must be allowed for the valve to react to
adjustments and the system to stabilize. The objective is to bring the valve into service in a controlled manner to protect the system
from damaging over-pressure.
1 – Main Valve (M100 - Single Chamber)
2 – 3-Way Solenoid
X – Isolation Cocks
Installation
LFM113-25 (Globe) Solenoid (On-Off) Control Valve with
Hydraulic Check Feature (4" and Smaller)
2 IOM-ACV-113-25_6113-25 2115
EDP# 1917083
© 2021 Watts
