AM Series Boilers and Water Heaters User Manual
CHAPTER 10
– MAINTENANCE
OMM-0100_E
•
GF-146
•
11/15/2019
Technical Support
•
(800) 526-0288
•
Mon-Fri, 8 am - 5 pm EST Page 128 of 170
10.14 Removing the Unit Covers
In order to remove the unit covers, refer to Figure 10-1 and follow the steps below:
Removing the Unit Covers
1.
Lift up, by hand, the Top Cover
“A”.
2.
Remove two Front Cover screws
“B”.
3.
Pull back the upper part of Front Cover
“C” for 2 inches, then pull it up for one inch and
remove it from the unit.
4.
Pull back upper part of Bottom Cover
“D” for 2 inches, then pull it up for one inch and
remove it from the unit.
5.
To gain access to the junction box:
a) Remove the Junction Box Cover screw
“E” at rear of cover.
b) Remove Junction Box cover
“F”.
Figure 10-1: Removing the Top and Front Covers
(F)
Junction
Box Cover
(A)
Top Cover
(C)
Front Cover
(D)
Bottom Cover
(E)
Junction Box Screw
(B)
Front Cover
Screws (2 each)
