![background image](http://html1.mh-extra.com/html/watts/aerco-benchmark-omm-0136/aerco-benchmark-omm-0136_operation-and-service-manual_4051813052.webp)
Benchmark Platinum-Edge [II]: Operation-Service Manual
SECTION 4
– INITIAL START-UP
OMM-
0137_E • GF-211 • 12/13/2019 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page
52
of
153
4.6 DUAL FUEL SWITCHOVER
All Benchmark Dual Fuel models contain a fuel selector switch, located to the right of the I/O
board, behind the front panel.
Figure 4-10: Dual Fuel Switch
Switchover from NATURAL GAS to PROPANE Instructions
1. Set
the Edge Controller’s
Enable/Disable
switch to
Disable
.
2. Close the external Natural Gas supply valve.
3. Open the external Propane gas supply valve.
4. Locate the Fuel Selector Switch (see Figure 4-10), behind the front door.
5. Set the Fuel Selector Switch from
NAT GAS
to
PROPANE
.
6. Replace the front door panel previously removed from the boiler.
Switchover from PROPANE to NATURAL GAS Instructions
1.
Set the Edge Controller’s
Enable/Disable
switch to
Disable
.
2. Close the external Propane Gas supply valve.
3. Open the external Natural Gas supply valve.
4. Locate the Fuel Selector Switch (see Figure 4-10), behind the front door.
5. Set the Fuel Selector Switch from
PROPANE
to
NAT GAS
.
6. Replace the front door panel previously removed from the boiler.
FUEL SELECTOR
SWITCH
I/O BOARD
and cover