15
For more cool and exciting Wattage products, visit our website at http://watt-age.globalhobby.com
❑
Push the end of the antenna through the predrilled
hole in the back of the hatch cover.
Push the antenna through from the bottom of the hatch
cover.
❑
Pull the antenna through the hole and set the hatch
cover back into place.
❑
Install and tighten the 2mm x 10mm wood screw to
secure the hatch cover to the fuselage.
IMPORTANT
The hatch cover will hold the receiver securely in place.
❑
Pull the antenna taut (but not overly tight) and use a small piece of clear tape to secure it to the back of the fuselage.
WARNING
Do not cut off the excess antenna. Let the excess hang behind the airplane. If you cut the antenna it will greatly reduce
the range of the receiver and you will lose control of the airplane.
Step 9: Connecting the Control Surfaces
❑
Turn on the transmitter. The green LED should light
up.
IMPORTANT
Before turning on the transmitter, check to make sure the
switch on the side of the fuselage is "off."
This will prevent unexpected radio signals from
interfering with your radio system.
