WATLOW ELECTRIC MANUFACTURING COMPANY
Installation & Maintenance Manual for MULTICELL
TM
Heaters
I&M MANUAL No: 316-42-21-1
Page: 5
Date: 3/15/2017
Rev: 5.00
WATLOW ELECTRIC MANUFACTURING COMPANY - 6 INDUSTRIAL LOOP RD.
– HANNIBAL, MO 63401 - PHONE 573-221-2816
Original Instructions (English)
CAUTION
Ensure that the element end seal temperature is kept below its temperature rating.
WARNING
The User must prevent live conductors from coming into contact with any fluids or
personnel.
All original enclosures and covers (where applicable), sensors and/or user controls,
etc must be correctly utilized in order for the safe operation of this product.
Warning: this product has not been designed for use in Classified (hazardous)
locations.
WARNING
It is the U
ser’s responsibility to ensure that the heater being used is properly
selected and installed in the application. This heater should only be used in the
application that it was originally designed for, and failure to do so could result in
damage to equipment or injury to personnel! For example, an immersion heater is
not likely suitable to be used for heating a gas because the watt density would be
too high.
These Heater components must be connected as per the Manufacturers
installation instructions and therefore must only be utilized in applications
suitable for the use of these components.
Typical applications include
–
•
Hot isothermal forming
•
Soil remediation
•
Hot forging dies
•
Heated platens
•
Super plastic forming
•
Heated platens (single and multiple zones)
•
Heat treating processes
•
Super plastic forming with diffusion bonding
