CLS200 Series User’s Guide
Chapter 3: Using CLS200
55
Acknowledging an Alarm
Press
ALARM ACK
to acknowledge the alarm. If there are other loops with alarm conditions, the
Alarm display switches to the next loop in alarm. Acknowledge all alarms to clear the global alarm
digital output (the keypad and display won’t work for anything else until you acknowledge each
alarm). The alarm symbols are displayed as long as the alarm condition is valid.
System Alarms
When a system alarm occurs, the global alarm output turns on and an alarm message appears on
the display. The message continues to be displayed until the error condition is removed and the
alarm is acknowledged. The CLS200 can display the following system alarms:
•
BATTERY DEAD
•
LOW POWER
•
AW
See
.
•
H/W FAILURE: AMBIENT
H/W Ambient Failure on page 144
•
H/W FAILURE: GAIN
H/W Gain or Offset Failure on page 145
•
H/W FAILURE: OFFSET
H/W Gain or Offset Failure on page 145
Job Display
The job display appears only if:
• You have enabled JOB SELECT DIG INPUTS. (See
Job Select Digital Inputs on page 68.
)
– or –
• You have selected a job from the job load menu.
After loading a job using the LOAD SETUP FROM JOB menu, the job display shows you the
following screen:
ALARM
JOB 3 RUNNING
If parameters are modified while the job is running, this screen will display:
ALARM
JOB 3 RUNNING
DATA MODIFIED
