Watkiss Vario, Operating Manual

Page: 53 / 110

49
6
Bench Base
Three different bases are available for the Vario, a bench
base, an oscillating bench base and a floor base. If your
machine is fitted with an oscillating bench base, please
refer to Section 7. If your machine is fitted with a floor
base, please refer to Section 8.
SETTING UP THE
STACKER
Take a few sheets of the stock to be collated and place
them in the stacker. Move the sliding sidelays in to fit the
width of the sheet.
Using
INCH
’park’ the stacker tamper in its forward posi-
tion. Hold the sheets so that the top edge is barely
touching the stacker tamper and then slide the end lay
up to meet the bottom edge of the sheet. Note that the
endlay is reversible to accommodate different paper
sizes.
For small sheet sizes, position the magnetic lays so that
they support the bottom corners of the stack. For large
sheet sizes they should be positioned at an angle along
the sides of the stack so that they guide the sheets and
ensure a neat stack.
OFFSET STACKING There are a number of ways in which the collated sets
can be separated in the bench base stacker. The choice
The Bench Base with A4 (8.5 x 11") Paper
The Bench Base with A3
(11 x 17") Paper.
Stacker Tamper
Sliding Sidelays
Magnetic Lay
End Lay