Watkiss P2T 2-Knife Trimmer User Manual
11
CHAPTER 4
Standard Tasks
Introduction
This chapter describes the standard tasks that are needed in the day-to-day
operation of your Side-Trimmer.
Adjust the Side-Trim Offset
Introduction
By default, the book is side-trimmed by an equal amount on each side. The
side-trim dimension is automatically calculated to trim 2.5mm from each side.
For example, if the book is 210mm wide, the default trim is 205mm. This side-
trim dimension can be changed. Touch
BASIC > SIDE TRIM
and then touch ‘
+
’ or
‘
-
’ to adjust the
TRIM SIZE
.
The side-trim can be offset from the centre line by a maximum of 40mm,
dependent on how much is to be trimmed. The machine will not permit a setting
that conflicts with the stitch position. Change the stitch pitch if necessary (see
“Adjust the Side-Trim Offset” on page 11).
If the
TRIM OFFSET
is changed, the icon changes to show the setting. The icon is
the same orientation as the book delivery out of the Side-Trimmer.