PRODUCT SUPPORT | 800.927.2120 | WATERWORKS.COM
PAGE 2 OF 4 | UPDATED ON 4.29.2021
STYLE No.
EEBT01
Emile 67” x 27” x 27-1/2” Freestanding Oval
Cast Iron Bathtub
INSTALLATION GUIDELINES
1. Dry-fit the DRAIN FLANGE and SHOE to the
BATHTUB using the DRAIN GASKET provided.
2. Dry-fit the OVERFLOW SHOE to the BATHTUB
using the OVERFLOW GASKET provided.
NOTE:
The UNWO76 is provided with 1 flat GASKET
and 1 wedge GASKET. Use the appropriate GASKET
to ensure the OVERFLOW SHOE is plumb.
3. Hold the TEE up to the DRAIN and OVERFLOW
PIPES then mark and cut the PIPES to the
appropriate lengths.
NOTE:
Ensure the PIPES will be inserted deep
enough into the TEE before cutting.
4. Connect the OVERFLOW to the DRAIN using the
TEE making sure the OVERFLOW PIPE is plumb
and there are no gaps between the OVERFLOW
GASKET and the BATHTUB.
5. If rough-in has
not been
completed, determine
the placement of the BATHTUB and mark the
floor where the TAILPIECE will pass through then
drill a hole through the floor to accommodate the
TAILPIECE.
NOTE:
A 3” diameter ESCUTCHEON is provided
with the UNWO76 to conceal the hole in the floor.
6. Rough-in 1-1/2” diameter piping and ensure all
piping and fittings are well supported to eliminate
the possibility of shifting.
DRAIN SHOE
RUBBER
GASKET
BATHTUB
DRAIN
FLANGE
* DRY-FIT
OVERFLOW
SHOE
RUBBER
GASKET
OVERFLOW
COVER
COVER
SCREW
* DRY-FIT
TEE
CUT MARK
[OVERFLOW PIPE]
CUT MARK
[DRAIN PIPE]
TEE
OVERFLOW
PIPE
[PLUMB]
* DRY-FIT
[FULL SEAL - NO GAPS]
FLOOR
BATHTUB
[MARK DRAIN LOCATION]
* POSITION BATHTUB
1-1/2" PIPE
[NOT SUPPLIED]
TRAP ADAPTER
[NOT SUPPLIED]
DRAIN HOLE
* ROUGH-IN
