FILTER CARTRIDGE
REPLACEMENT
STEP
1
Turn off the water supply to the system by shutting off the
inlet and outlet valves on the bypass.
STEP
3
Depressurize the system by pushing down on the red
depressurization button on the top cap of the system.
Keep the button pushed down until all the air or water
pressure is completely released.
STEP
6
Remove the top cap of the system by lifting
up on the top handles.
STEP
9
Look down into the tank assembly, and you should see
a small opening centered in the bottom of the tank.
STEP
2
Install a 3/8” PEX tubing hose to the provided
John Guest
®
fitting and shut-off that connects to the
inlet side of the filtration system. Run the hose to a
floor drain or bucket, and use to drain sediment or
to aid in filter removal during change-out.
STEP
4
Push down the top cap with both hands to unseat the
retaining ring.
STEP
7
Remove old filter and discard.
STEP
10
Remove packaging from the new filter cartridge and place
into the tank with the double O-ring facing down.
STEP
5
Remove the retaining ring by carefully grasping the handle
and pulling inward, then upward. The retaining ring should
slide completely out of the groove.
STEP
8
Open the John Guest
®
fitting shut-off, and
flush out the bottom.
STEP
11
Position the filter cartridge so that it is aligned
with the bottom, center opening.
NO TOOLS
REQUIRED
2
