COUNTER
OR SINK
1-3/8”
HOLE
A
B
C
D
F
G
E
B
C
COUNTER
OR SINK
1-1/2”
HOLE
A
EXPOSE
THREADS
D
1.
2.
3.
4.
1.
2.
3.
4.
5.
6.
INSTALL AIR SWITCH (OPTIONAL)
INSTALL SOAP/LOTION DISPENSER (OPTIONAL)
Fill plastic bottle with soap or lotion. Thread
bottle (E) into bottom of dispenser shroud.
Pull and remove spout
(A) from dispenser body
(B). Remove clamp nut
(C) and brass spacer (D)
from threaded shroud.
Slide red tubing (F)
into tube fitting (G)
at bottom of spout.
Insert open end of
red tubing down
through dispenser
base and into
plastic bottle.
Push down on spout
to secure over white
O-rings.
Pump spout a few
times to get soap or
lotion flowing.
Fit dispenser body through 1-3/8” hole
on counter or sink.
(No plumbers putty is
required)
. Slide brass spacer onto shroud.
Screw clamp nut and tighten snug.
Slide washer up then screw the
clamp nut onto threaded shroud.
Hand tighten nut to underside of
sink or counter until snug.
Slide clear tubing
(B) into tube
fitting (C) at
bottom of air
switch shroud.
CONTINUED ON NEXT PAGE
Fit air switch and tubing through
1-1/2” hole on counter or sink.
(No plumbers putty is required.
O-ring seals base)
.
Before inserting air switch into
hole, loosen switch base (A)
until threads are exposed.
