Watersnake Slider Pro, Owner'S Manual, Page: 4 / 20

Watersnake
4
SET UP
Pulling the quick locking and release mechanism on the mounting bracket will
release the locking collar cradles and allow you to slide the motor forward and
away from the mounting bracket. Make sure you support the motor assembly
or head unit when deploying the motor and that it locks into the vertical
position securely.
DEPTH ADJUSTMENT
Hold the motor shaft with one hand, loosen the depth collar adjustment screw
and set the motor to the desired depth. Then retighten the adjusting screw on
the depth collar securely.
STOWING
When the Watersnake is not in use always stow it properly. Release the quick
lock and release lever and raise the motor and pull towards the stern until it is
secure on the locking cradles and locked in the horizontal position out of the
water.
FOOT PEDAL CONTROL SYSTEM
(Please refer to foot control system diagram on page 5)
The low profi le foot pedal control is used to adjust direction and speed. A
variable speed dial control is located at the right side of the foot control box.
(1) Steering is enabled via the buttons marked left and right.
Pushing down on the button marked “L” at the top left hand corner of the
pedal with your foot will turn the motor to the left
(2) To steer to the right push your foot down on the button marked “R” at the
top right hand corner of the pedal.
(3) Use your heel at the bottom of the pedal to pause or resume thrust power
(4) A constant on/off switch is set at the left hand side of the foot pedal control box.
To set the power of the motor to off the constant on/off switch should be in the
backwards position with the tail end pointing down towards you.
To set the power of the motor to on, the constant on/off switch should be moved
to the forward position with the tail end pointing up.
(5) Variable speed control dial.