4-6
Verifying System Operation
Creating the test methods
Follow the steps below to create the methods, setting the parameter values to
match those reflected in the accompanying screen representations. This
method is designed as a rapid test procedure implementing a 150-
µ
m ID
column at high flow rate.
Creating the instrument method
To create the instrument method:
1.
Create an instrument method with these binary solvent manager
parameters.
Exception:
If you use the 75
µ
m ID
×
100 mm column, in the gradient
table, enter 0.300
µ
L/min as the flow rate.
Binary solvent manager instrument parameters (General tab):
Summary of Contents for nanoACQUITY UPLC
Page 7: ...vii ...
Page 16: ...xvi ...
Page 20: ...xx Table of Contents ...
Page 32: ...1 12 System Overview ...
