Waters 2475, Operator'S Manual, Page: 73 / 228

3-1
3
Using the Detector
After you install the detector, you must set it up and operate it as a
standalone instrument or as part of a data system.
•
As a standalone instrument – You can use the detector as a
standalone detector with a system such as the Waters Alliance
system or with any pump, injector, chart recorder, or integrator.
You can program the detector’s front panel unless it is controlled by
a data system such as Waters Empower or Millennium
32
software.
• As part of an Empower system – You can configure the detector for
use in an Empower system. To do so, follow the instructions in the
Empower Online Help to set parameters for controlling the detector.
• As part of a Millennium
32
chromatography workstation – You can
configure the detector for use with a Millennium
32
chromatography
workstation, version 3.2 and later. To do so, follow the instructions
in the
Millennium
32
Online Help to set parameters for controlling
the detector. In Millennium
32
Chromatography Manager, version
3.2 and later, the detector is configured in 474 Emulation mode and
recognized by Millennium as a 474 detector.
Contents:
Topic Page
Starting the detector 3-2
Using the operator interface 3-4
Preparing to start a run 3-18
Operating the detector 3-28
Programming methods and events 3-43
Scanning spectra 3-52
Managing results 3-65
Conserving lamp life 3-67
Shutting down the detector 3-70