ES-CUTP and ES-FUTP Manual
Page 2
1.0 SPECIFICATIONS
1.1 Technical
Specifications
Ports Performance
When a port is operating at 100Mbps:
Data Rate: 100Mbps
When a port is operating at 10Mbps:
Data Rate: 10Mbps
Network Standards
100Mbps: Ethernet IEEE 802.3u, 100BASE-TX, 100BASE-FX
10 Mbps: Ethernet IEEE 802.3, 10BASE-T
Auto-sensing for speed: IEEE 802.3u
Packet-Processing Between Domains
Filtering and Forwarding Rate from 100Mbps ports: 148,800 pps max
Filtering and Forwarding Rate from 10Mbps ports: 14,880 pps max.
Processing type: Store and Forward
Auto-learning: 16K address table, shared for all traffic domains
Packet buffers: 1024KB, dynamically shared on all domains
Latency (not including packet time): 100 to 10Mbps: 5
µ
s
10 to 100Mbps: 5
µ
s
Path Delay Value
: 50 BT on all ports
Maximum Ethernet Segment (or Domain) Lengths
10BASE-T (Unshielded twisted pair)
100 m (328 ft)
100BASE-TX (Category (CAT) 5 UTP)
100 m (328 ft)
100BASE-FX, half-duplex: (multi-mode)
412 m (1350 ft)
100BASE-FX, full-duplex: (multi-mode)
2.0 km (6,562 ft)
Operating Environment
Ambient
Temperature: 32
º
F to 104
º
F (0
º
C to 40
º
C)
Storage
Temperature: -5
º
C to 160
º
F (-20
º
C to 70
º
C)
Ambient Relative Humidity: 10% to 95% (non-condensing)
Power Supply (External)
Input:
95-125 vac at 60Hz
Output:
5VDC, 2Amps
Polarity: center positive, shell negative
Power Consumption: 8 watts typical, 10 watts max.
Network Cable Connectors -
for eight RJ45 shielded female ports and 1 fiber port
100Mbps: CAT5 UTP/STP, fiber (50/125, 62.5/125, 9/125 micron)
10 Mbps: CAT3, 4, 5 UTP (Note: auto-sensing does not sense cable type)
Maximum Load per port: 60 mA
Uplink, Port #1 or 1SW
Port #1 (switched RJ45) has a manual crossover (MDIX uplink) switch for connection to a
central switch or to another ES switch (or equal) unit. The uplink port #1 is auto-sensing for
speed, and its auto-negotiating uplink feature works the same at 10Mbps or 100Mbps and at
full- or half-duplex mode.
Full- or Half-Duplex selection on switched Ports #2 or 2SW for ES-FUTP-8
Manual switch selects fiber port for FDX or HDX. See Section 4.3 for details.
Full-Fixed or Auto-negotiation selection on switched Ports #2 or 2SW for ES-CUTP or ES-
FUTP
Manual switch selects port #2 for “FF” or “A”. See Section 4.3 for details.
