8
8
6
8
6
Fill
High
Low
Power
ON
Power
ON
Water
ON
Water
ON
Insert
Tip
eject
button
Powering the Unit
Plug the cord into an electrical outlet. If the outlet is controlled by a wall switch, be
sure it is turned on.
Preparing the Reservoir
Lift the reservoir lid, remove the reservoir, and fill with lukewarm water. Replace the
reservoir over the base and press down firmly and close the lid.
Inserting and Removing Tips
Insert tip into the center of the Water Flosser handle, pressing down firmly until tip
clicks into place. The colored ring will be flush with the top of the handle if the tip is
correctly locked into place.
To remove tip from the handle, slide the tip eject button on the handle.
Caution: Do not use tip eject slide while unit is running.
Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure setting No. 10), point the
handle and tip into sink. Turn unit ON and water ON until water flows from the tip.
Turn Power Off.
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the unit to the lowest setting (pressure
setting No. 1) for first-time use. Gradually increase pressure over time to the setting
you prefer – or as instructed by your dental professional.
Using the Water Flosser
Always place the tip in your mouth before turning the water ON.
With water
switch in OFF position, turn power on.
Lean over sink and slightly close lips
enough to prevent splashing while still allowing water to flow from mouth
into the sink. Turn water switch ON. When finished, turn water switch and
power OFF.
During use you can stop the flow of water by sliding the water switch
on handle to the OFF position.
NOTE: Motor will continue to run.
GETTING STARTED WITH YOUR WATER FLOSSER