Waterpik WP-70 Series, Instruction Manual

Page: 6 / 66

66
Powering the Unit
Plug the cord into an electrical outlet. If the outlet is controlled by a wall switch, be sure it is turned on.
Inserting and Removing Tips
Pull the knob on the top of the handle toward the hose and insert tip into the center of the knob. The colored ring will be flush
with the end of the knob if the tip is correctly locked into place.
To remove tip from the handle, pull the knob on the top of the handle toward the hose and pull tip from handle.
Preparing the Reservoir
Remove reservoir from base. Fill the reservoir with lukewarm water. Replace the reservoir over the base and press down firmly.
Prime Unit (First Time Use Only)
Set pressure control dial on base to high, point the handle and tip into sink. Turn unit ON (I) until water flows from the tip.
Turn unit OFF (O).
Adjusting the Pressure Setting
Slide the pressure control switch located on the handle to the lowest setting (away from the tip as far as possible) for first-
time use. Gradually increase pressure over time to the setting you prefer – or as instructed by your dental professional.
Recommended Technique
For best results, start with the back teeth and work toward the front teeth. Glide tip along gumline and pause briefly between
teeth. Continue until you have cleaned the inside and outside of both the upper and lower teeth.
Lean over sink. Direct the stream at a 90-degree angle to your gumline with tip in mouth.
Slightly close lips to avoid
splashing , but allow water to flow freely from mouth. Set pressure at desired setting and turn the unit ON (l). Begin cleaning.
Pause Control
You can temporarily stop the flow any time by pressing the pause button on the handle.
Eject Insert
OZ. ML.
1000
900
800
700
600
500
400
300
200
5
10
15
20
25
30
35
Fill
Pressure
Setting
GETTING STARTED