9
8
E
N
G
LIS
H
E
N
G
LIS
H
9
8
Plaque Seeker™ Tip
To use the Plaque Seeker™ tip, place the tip close to the teeth so that the bristles are gently touching the teeth.
Gently glide tip along gumline, pausing briefly between teeth to gently brush and allow the water to flow between the teeth.
Water Spill Over Protection
When traveling, place travel plug in unit to keep excess water from draining out.
NOTE: Do NOT run unit while travel water plug is in unit.
Using Mouthwash and Other Solutions
Your Waterpik® Water Flosser can be used to deliver mouthwash and antibacterial solutions. For ease of adding other solutions
remove the reservoir (see “When Finished” section) and add from top opening on reservoir. If you are adding additional water you
may replace the reservoir and fill reservoir fully with the fill door. After using any special solution, rinse unit to prevent clogging by
partially filling reservoir with warm water and running unit with tip pointed into sink until unit is empty.
Cleaning
Never immerse unit in water. Before cleaning, unplug from the electrical outlet. Clean the product when necessary by using a soft
cloth and mild non-abrasive cleanser to wipe exterior.
The water reservoir is removable for easy cleaning and is top rack dishwasher safe, turn heat cycle off. It is recommended that the
reservoir is removed and cleaned weekly.
Removing Hard Water Deposits / General Cleaning
Hard water deposits may build up in your unit, depending on the mineral content of your water. If left unattended, it can hinder
performance.
Cleaning internal parts: add 1 tablespoon of white vinegar to a full reservoir of warm water. Point the handle and tip into sink.
Turn unit ON and run until reservoir is empty. Rinse by repeating with a full reservoir of clean warm water.
This process should be done every 1 to 3 months to ensure optimal performance.
Battery Removal
The product contains a rechargeable lithium-ion battery and/or electronic waste. In order to protect the
environment, please do not dispose along with household waste. When battery life ends, please dispose
or recycle according to local administrative regulations.
Please contact local waste administrative department for any questions.
If you intend to dispose the battery on your own, please discharge battery fully before removal.
Wear appropriate Personal Protective Equipment (i.e. goggles, gloves) before attempting the
battery removal.
1. Remove Reservoir
2. Remove Tip Rotator by prying it up with a small flat-head screwdriver
3. Remove 4 small screws
4. Remove decorative trim piece and jet tip latch mechanism
5. Remove 4 screws
6. Remove rear handle housing
7. Cut the plastic housing as shown
8. Pull out the battery and cut connecting wires
The removed battery should be disposed safely by special recycling center.
WARNING:
The battery of this product is not replaceable. Please do not disassemble the product
unless you want to dispose it. Otherwise the warranty service will be void.
CLEANING AND TROUBLESHOOTING YOUR WATERPIK® WATER FLOSSER
BATTERY REMOVAL
Remove
5.
7.
8.
1.
3.
4.
2.
6.
5.
7.
8.
1.
3.
4.
2.
6.
