66
Charging Unit Prior to First Use
Plug the power cord into the wall and place the magnetic charger on the front of the unit for approximately 4 hours (see
image). The charge indicator on the handle will flash when charging and will turn off when the unit is fully charged. A full
charge will last for approximately 1 week of typical use. When the batteries are in need of charging (approximately 30%
charge left) the charge indicator light will blink 8 times quickly after use to indicate that you should recharge the unit. A
complete recharge will take 3-4 hours. If you use your Water Flosser once a day or less, it is recommended you charge it
once a week. If you use it twice a day or more, charge the unit more frequently.
Filling the Reservoir
Remove the magnetic charger from the unit prior to filling reservoir and product use. Lift flip top on reservoir and fill the
reservoir with lukewarm water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water Flosser handle. Press firmly until the tip clicks into place. To
remove the tip from the handle, press the tip eject button and pull tip from the handle.
CAUTION: Do not press tip eject button while unit is running.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser by pressing the mode button on the handle. Start with the
lowest setting and increase to your liking.
GETTING STARTED
MODE
HIGH
LOW
MEDIUM
Eject
Fill
MODE
HIGH
LOW
MEDIUM
Pressure
Setting
MODE
HIGH
LOW
MEDIUM
MODE
HIGH
LOW
MEDIUM