24
25
E
N
G
LI
S
H
Recommended Technique
Lean low over sink and place the tip in mouth.
Aim the tip toward teeth, and turn the unit ON (I).
For best results, start with the back teeth and
work toward the front teeth. Glide tip along gumline and pause briefly
between teeth. Continue until you have cleaned the inside and outside of
both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline.
Slightly close
lips to avoid splashing
but allow water to flow freely from mouth into the
sink. Keep unit upright during use for best results.
When Finished
Turn the unit OFF (0). Empty any liquid left in the reservoir. If desired, the
reservoir may be removed from the power handle by pulling the reservoir
release latch while sliding the reservoir down towards the base of the unit.
To replace the reservoir on the power handle, simply slide it up towards
the top of the unit. The reservoir will snap into place when fully engaged.
GETTING STARTED
Replacement tips/attachments may be purchased from your local distributor, which can be found at www.waterpik.com/intl.
Classic Jet Tip
BEST FOR
Tongue Cleaner
BEST FOR
General Use
Fresher Breath
Replace Every 6 Months
Plaque Seeker
®
Tip
BEST FOR
Toothbrush Tip
BEST FOR
Implants
Crowns
Retainers
Bridges
General Use
BEST FOR
Orthodontic Tip
General Use
General Use
Braces
BEST FOR
Pik Pocket
™
Tip
Periodontal Pockets
Furcations
Replace Every 3 Months
Charger
Waterpik
®
p/n 20016190 (White)
Waterpik
®
p/n xxxxxxxx (Black)
Charging Unit Prior to First Use
Plug the cord into any standard electrical outlet.
Make sure you push the switch into the “OFF” (0)
position before charging. The unit will not charge if
the switch is in the “ON” (I) position. See “Cleaning
and Troubleshooting Your Waterpik
®
Water Flosser”
for guidance on how to look after your battery. The
Waterpik
®
Water Flosser will stay charged for up to 2
weeks depending on use.
Filling the Reservoir
Disconnect charging cord from the unit prior
to filling the reservoir and product use. Lift
flip top on reservoir and fill the reservoir with
lukewarm water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water
Flosser handle. Press firmly until the tip clicks into place.
To remove the tip from the handle, press the tip eject button
and pull tip from the handle.
CAUTION: Do not press tip eject button while unit
is running.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water
Flosser by simply sliding the pressure switch on the handle.
NOTE: All tips not included in all models.
Tip eject
button
Pressure
Setting
Reservoir
Release Latch
20021794-FAA_WP450B_IM_revs_rd6.indd 24-25
4/26/16 2:28 PM
